Traceable
®
is a registered trademark of Control Company ©2009 Control Company. 92-3422-00 Rev. 1 031909
Once the count-up timing has been stopped, pressing the
H
,
M
, or
S
buttons
will increment the display from the point that it was stopped and will set the timer
into countdown mode. (This will also clear the previous countdown time from
memory.)
MEMORY RECALL
When timing repetitive intervals, the memory function will recall the last
countdown time.
1. Follow steps 1 through 4 in the “Countdown Alarm Timing” section.
2. Once the count up timing has been stopped, press the
S/S
button to
recall the original programmed time.
3. Press the
S/S
button to begin countdown timing.
STOPWATCH (COUNT-UP) TIMING
1. Clear the display to zero.
2. Press the
S/S
button to begin count-up timing.
3. Press the
S/S
button to stop count-up timing.
Once timing is completed and the timer has been stopped, press the
C
button to
clear the display to zero.
TIMEOUT
The timer may be stopped during any running time (countdown or count-up) by
pressing the
S/S
button. Timing may be resumed by pressing the
S/S
button.
CONVERT A TIMEOUT TO A COUNTDOWN TIME
The timer may be stopped during any running time (countdown or count-up) by
pressing the
S/S
button. Once the timing has been stopped, pressing the
H
,
M
, or
S
buttons will increment the display from the point that it was stopped
and will set the timer into countdown mode. Once the desired time is on the
display, press the
S/S
button to begin countdown timing.
ALL OPERATIONAL DIFFICULTIES
If this timer does not function properly for any reason, replace the battery with a
new high quality battery (see “Battery Replacement” section). Low battery power
can occasionally cause any number of “apparent” operational difficulties.
Replacing the battery with a new fresh battery will solve most difficulties.
BATTERY REPLACEMENT
An incorrect display, no display or operational difficulties indicate that the battery
should be replaced. Slide open the battery cover on the back of the timer.
Remove the exhausted battery and replace it with a new 1.5 volt silver-oxide 357
size battery. Make certain the positive (+) side is visible. Replace the battery
cover.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
www.control3.com
Control Company is ISO 9001 Quality-
Certified by DNV and ISO 17025 accredited
as a Calibration Laboratory by A2LA.
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels