Control-company 3133 COUNTER PEN Manuel d'utilisateur télécharger pdf

Traceable

SPECIFICATIONS

Counting Capacity: 99,999

OPERATION

Count without Marking

1. Turn the unit on by sliding the ON/OFF switch to the ON

position.

2. With the silver pen cap in place, press the tip of the unit against

the item to be counted with sufficient pressure for the tactile

feedback “click” to be felt. The display will increment by 1 and

the unit will beep

3. Release pressure.

4. Continue to “point...press...click...release” until counting is

completed.

5. Once counting has been completed, the felt tip pen on the unit

may be used to record the count.

6. Turn the unit off by sliding the ON/OFF switch to the OFF

position. To preserve battery life, always turn the unit off when it

is not in use

Count with Marking

1. Remove the silver cap from the tip of the pen.

2. Turn the unit on by sliding the ON/OFF switch to the ON

position.

3. Press the tip of the pen against the item to be counted with

sufficient pressure for the tactile feedback “click” to be felt. The

display will increment by 1, the unit will beep

, and the pen will

leave a mark

on the counted item.

Important:

Press just hard enough for the tactile feedback “click” to be felt. Only 6.5

ounces (184 grams) of pressure is required. Do not to press so hard that the

felt tip of the pen is pushed up into the pen body.

4. Release pressure.

5. Continue to “point...press...click...release” until counting is

completed.

6. Once counting has been completed, the felt tip pen may be

used to record the count.

7. Turn the unit off by sliding the ON/OFF switch to the OFF

position. To preserve battery life, always turn the unit off when it

is not in use

8. Place the cap back on to the felt tip pen. To prevent the pen

from drying out, always replace the pen cap when the pen is not

in use.

Reset Counter to Zero

The counter may be set to zero at any time by pressing the RESET

button, or by turning the unit off.

Operational Notes

1. When pressing in rapid succession, the unit will not beep each time the

display is incremented. The display will increment each time sufficient

pressure is applied for the tactile feedback “click” to be felt.

2. The ink is water based and is not permanent. The pen will leave a small

mark on nonporous surfaces; however, the mark will be removed when

the surface is wiped, or when the ink evaporates from the surface.

3. The counter is reset to zero when the unit is turned off.

PEN CARTRIDGE REPLACEMENT

1. Remove the silver cap from the tip of the pen.

2. Grasp the tip of the unit at the four rings, turn counter clockwise

and unscrew the tip from the unit.

3. Remove the exhausted pen cartridge and replace it with a fresh

new cartridge.

4. Replace the tip of the unit and tighten securely.

5. Place the cap back on to the felt tip pen. (Use the original silver

cap, do no use the temporary cap that came with the

replacement pen cartridge.)

ACCESSORIES

Control Company Cat. No. 3135 - black

Control Company Cat. No. 3134 - green

Replacement Pen Cartridge

Control Company Cat. No. 1104 -

Replacement Battery

ALL OPERATIONAL DIFFICULTIES

If this unit does not function properly for any reason, replace the

battery with a new high-quality battery (see “Battery Replacement”

section). Low battery power can occasionally cause any number of

“apparent” operational difficulties. Replacing the battery with a new

fresh battery will solve most difficulties.

BATTERY REPLACEMENT

Erratic readings, a faint display, or no display are all indications that

the battery must be replaced. Remove the screw located on the

pocket clip on the back of the unit. Remove the back of the unit. The

battery is held in place sideways at the top of the pen. Remove the

exhausted battery and replace it with a new #392 size Silver Oxide

battery. Make certain to insert the battery with proper polarity as

indicated by the illustration in the battery compartment. Replace the

back of the unit. Replace the screw and tighten securely.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax 281-482-9448

E-mail [email protected]

www.control3.com

Control Company is ISO 9001 Quality-

Certified by DNV and ISO 17025 accredited

as a Calibration Laboratory by A2LA.

COUNTER PEN™ INSTRUCTIONS

Résumé du contenu

Page 1 - COUNTER PEN™ INSTRUCTIONS

Commentaires sur ces manuels

Pas de commentaire

Control-company 3133 COUNTER PEN Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Instruments de mesure Control-company 3133 COUNTER PEN. Control Company 3133 COUNTER PEN User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Control-company 3133 COUNTER PEN